繁體版     English

E-mail:susan@brakepad.cn     +86-532-66736778

Welcome

News

The reason why the brake pad just changed is hot and burnt?

[Catalog:News] [Date:2022-4-15] [Hits:] [Return]

The reason why the brake pad just changed is hot and burnt? Because the distance between the brake pad and the brake pad is too small or the brake cylinder is stuck and locked. Often stepping on the brake will cause the temperature of the brake disc to rise. In serious cases, it will lead to the destruction of the brake pad and the invalidation of the brake system.

Precautions for brake pad replacement: during the prime time of brake pad replacement, the thickness of the brake pad of the disc brake can be checked by stepping on the brake system board, while the thickness of the brake pad on the drum brake system shoe should be checked by pulling the brake system shoe out of the brake.

However, whether it is the brake pad on the disc brake or the brake pad on the drum brake, the manufacturer requires that its thickness should not be less than 1.2mm. Because, according to all the specific and accurate measurement instructions: before or after 1.2mm, the brake pad will be damaged and fall off faster.

Therefore, the buyer should check and replace the brake pads on the braking system at this time or before. Under normal driving conditions, the service life of the brake pads of the front braking system is more than 30000-50000 km and that of the brake pads of the rear braking system is more than 12000-150000 km.

After the brake system is installed, the tire should be calibrated. When installing the tire screws, tighten the corners to help maintain the tire and brake pedal rim. At the same time, it is also necessary to check whether the damage of the tread and edge is normal. It is best that the left and right wheels can be replaced and applied on time, which will be beneficial to increasing the service life of the tire. Finally, check the brake oil.

The brake fluid should be removed, replaced and added on time. At the same time, it should be ensured that the model of service brake oil is consistent with that of the original brake oil, which will help to eliminate the oil dirt and stains in the brake system pipeline and make the brake system more flexible. If the brake oil of different models is mixed, it will produce chemical reaction, resulting in the accumulation of oil dirt and carbonate in the brake system. The daily accumulation of moon fruit will block the pipeline, resulting in the invalidation of the brake system, and the adverse effects are unimaginable.